 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-16-2016 |
| Location: | |
| Posts: | 71 |
| Status: |
Offline
|
I have e3 3.46 model spark plugs, all plugs look good. using magnecor 8mm wire, they look good bought them 3 years ago... 3000 miles usage. last july i replaced the pertronix ignitor it started failing. Inspected the rotor and cap both looked like new. I am using the pertronix matching coil, its voltage checks out on bench test... but loose connection could be issue. which HV cables are you referring too?. The alternator is a new , bought last year a 35 amp one for about 70 bucks. it show 14.5 + output while driving. Going to check the fuel tank for loose particles. the tank was in poor condition when I got the car. Cleaned it and coated it with an epoxy kit sold at motorcycle shops. I'll drive it tomorrow and see it reoccurs. weather permitting.also, i have an electric fuel pump with an low oil pressure switch to cut fuel to the engine during an accident, that would cause the engine of shut down by shutting off the fuel pump?
Last edited on 11-15-2018 08:28 pm by jomac