 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 01-29-2017 |
| Location: | Phoenix |
| Posts: | 51 |
| Status: |
Offline
|
As to #7 - ("plug" with 1 3/8" drain tubing and solder it to a copper plate) - would you happen to have pix of this? I was thinking of reinstalling the slip yoke of the driveshaft while pulling and reinstalling but it did sound like it would get in the way. The plug sounds nicer if I can make one.
On #6, what does the #4 crosspoint screw under the starter do/attach to?
I'm sure I'll have more questions as the swap day comes up, but I'm printing this out as it seems very helpful!