View single post by Brett Gibson JH5 20497
 Posted: 10-04-2005 02:49 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 712
Status: 
Offline
Check that the cable is running a smooth path to the speedo, make sure that it is fully enganged into the back of the speedo and trans., make sure the inner cable ends are not rounded off, and finnally if all else fails you might try pulling the speedo and cleaning/lubing it, this is a last resort due to them being very delicate.

Good luck     Brett.