View single post by edward_davis
 Posted: 09-25-2005 07:05 pm
PM Quote Reply Full Topic
edward_davis



Joined: 07-06-2005
Location: Eugene, Oregon USA
Posts: 162
Status: 
Offline
 Well, I've added my switch, and it works, but it doesn't fit the dash cutout perfectly.  There seems to be about a millimeter on each side, left and right.  The top-bottom size is fine, so it doesn't shift around.

I had to make a pretty radical change to my flasher circuit to get it to work though.  I've run both the hazard and turn signal circuits through a single flasher unit.  The power comes from the battery, through a fuse, to the flasher (formerly the hazard flasher) and into the switch.  Then the power either goes 1) to the turn signal switch or 2) directly to the marker lights through the original hazard wires.

I've posted pictures and more description on the Photo Gallery:

http://jhppg.com/gallery/album01