View single post by Spaceman
 Posted: 06-13-2017 06:51 pm
PM Quote Reply Full Topic
Spaceman



Joined: 05-30-2017
Location:  
Posts: 25
Status: 
Offline
I have the same problem, oil pressure too high, so looking at the picture, which one is the valve? Appears to me its the little cylinder with the holes, and the other end with the o-ring is a retainer.

Also, I have successfully repaired my oil gauge which also bent past 100, seems if they go too far, a little wire pops out of the needle. All you need to do is pull the bazel, undo the nut on the back, and reposition the wire back in the needle. The bladder doesn't appear bent too much.