 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-16-2016 |
| Location: | |
| Posts: | 71 |
| Status: |
Offline
|
| View single post by jomac | |||||||||||||
| Posted: 02-03-2017 11:23 pm |
|
||||||||||||
jomac
|
When inspecting the front bearing I removed the hub rotors asm, looking to separate the rotor from the hub . But I found a large flat disc about 5" dia pressed on to the rotor and covering the rotor bolts. It looked like the dust seal was attached to it. How do you remove the part? The manual doesn't show this part.
|
||||||||||||
|
| |||||||||||||