View single post by dbeliveau74
 Posted: 01-18-2017 05:03 am
PM Quote Reply Full Topic
dbeliveau74



Joined: 12-28-2015
Location:  
Posts: 37
Status: 
Offline
Finally got the header now to install it!!
My Jensen Healey Shop manual Printed by Motorbooks International doesn't describe this procedure. I've read on here about 2 possibilities 1 remove the engine completely an 2 unbolt the left motor mount and loosen the others and tilt the engine. is there an approved or best solution. I'm in tight quarters in my garage and an engine hoist will be tight. Where would one attach the lifting chain...? Or jack the block from under with wood to block against the alum oil pan? Also I have to replace the steering column bushing at the firewall and that isn't described at all. ;-{