View single post by qwerty
 Posted: 11-22-2016 05:25 pm
PM Quote Reply Full Topic
qwerty



Joined: 10-01-2016
Location: Australia
Posts: 77
Status: 
Offline
The shoulder that touches the boss on the seal cover can't be enlarged. It presses through the bearing bore from front to rear, so bore-size is as big as it can get.
Heyyy? Not sure we're on the same page here. See pic below.

1) not having sufficient travel to achieve enough tension on a range of belts, and 2) being way too hyper-sensitive.
3) I trust Lotus did their homework on the offset as well so i'm mindfull of that too.


Attachment: 1.jpg (Downloaded 140 times)