 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-01-2016 |
| Location: | Australia |
| Posts: | 77 |
| Status: |
Offline
|
This is a no go, the spigot diameter is fine but it is too is too long for the J-H front housing. Additionally once we faced the spigot down to size on a lathe so it would fit, the bearing sits too far inward so the belt will be running off the front edge, not by much ~3mm yet enough to cause a bit of worry.
I will be exploring this in the future to make another part suitable for a replacement for the J-H.
Last edited on 11-22-2016 09:33 am by qwerty