 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 05-01-2005 |
| Location: | Minneapolis, Minnesota USA |
| Posts: | 573 |
| Status: |
Offline
|
I am in the process of bolting things back onto my rebuilt engine, and in doing so when I looked into the belt tension-er whole to put the stud back in, I noticed that the new front cover gasket was protruding slightly into the whole on just one side. Thinking this might put the tension-er bearing slightly off kilter I cleaned the bit out of the whole. Could this be an issue on just were the belt run's, I don't know, but the thought crossed my mind.That shouldn't be a problem.
Regards,
Tim Engel