View single post by Screenplay
 Posted: 11-06-2016 05:05 pm
PM Quote Reply Full Topic
Screenplay

 

Joined: 07-12-2013
Location: San Francisco, California USA
Posts: 121
Status: 
Offline
Is the "upside down" a reference to the position of the eccentric? The pic looks like it's installed according to the WSM - that is, tension is increased by turning the eccentric nut clockwise. However, as I recall Tim Engel has posted a tuotial recommneding turning the eccentric 180ยบ so tensioning is increased by turning counterclockwise - I believe a failsafe in case the nut loosens.

Or perhaps it just looks upsidedown because qwerty is on the opposite side of the eqautor from many of the commentors here.

Clinton

Last edited on 11-06-2016 05:05 pm by Screenplay