View single post by Frank Schwartz
 Posted: 11-06-2016 03:22 pm
PM Quote Reply Full Topic
Frank Schwartz

 

Joined: 02-18-2011
Location:  
Posts: 313
Status: 
Offline
 From the picture, it looks correct...and it appears to be the two bearing type....I do not understand how it could be "upside down"... Remember, to remove it, you will have to slide off the crankshaft pulley....
I still have the single bearing unit on my bench and have not replaced the single bearing in it yet.

I have been working on Mike Linn's daughter's JH and just when I thought I was finished inside, I found the fan frozen and had to take the entire inside out to replace it. Also found many electrical problems that I had to fix...wiring on early JHs is not the exact same as later models, I found out....