View single post by NigelK
 Posted: 08-21-2016 12:47 pm
PM Quote Reply Full Topic
NigelK

 

Joined: 07-16-2014
Location:  
Posts: 200
Status: 
Offline
 Thanks all. Turns out my GT indeed has hubs with the later metal collar (shield) and small rubber seal. The new hub oil seal is very different, a hard rubber ring with a spring-loaded lip. Here are some photos:




Question is, how do I install this seal? No instructions came with it. Do I press it onto the widest part of the spindle like this?


Or do I press it into the hub like this (NB in this photo I have not pressed the seal all the way into the hub, just in case I need to remove it again and risk damaging it)?


Any advice much appreciated...

Last edited on 08-15-2017 07:46 pm by NigelK