 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-10-2008 |
| Location: | |
| Posts: | 3 |
| Status: |
Offline
|
I have quite wide panel gaps so if the rear fenders are fixed and there is only a small amount of adjustment in the fronts then I am not going to be able to achieve the tight panel gaps seen on some of the photos on here.
Do you know how the tight panel gaps are achieved? Do you have to build up the rear of the front fender to make it longer? If so that is outside my shill set and sounds expensive....