 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-17-2005 |
| Location: | Hilton, New York USA |
| Posts: | 798 |
| Status: |
Offline
|
Good luck and take your time.
Last edited on 05-04-2016 01:07 pm by Brett Gibson JH5 20497
| View single post by Brett Gibson JH5 20497 | |||||||||||||
| Posted: 05-04-2016 01:06 pm |
|
||||||||||||
Brett Gibson JH5 20497
|
There is no adjustment on the rear fenders, so they went on 1st in my case, followed by the fronts, can't install the fronts if you put the doors on before, then the doors, you can move the fronts about slightly but most of the movement is the DOORS, be patient with them they can be a PITA. Once all that is in place trunk or hood doesn't matter which, only the hood you can still move the fenders a bit in and out for better gap. But the hood is best done with two people, and if the back of it is riding high open it up as high as you can and retighten that will get it to sit lower. Good luck and take your time. Last edited on 05-04-2016 01:07 pm by Brett Gibson JH5 20497 |
||||||||||||
|
| |||||||||||||