View single post by Mark Rosenbaum
 Posted: 09-07-2005 03:25 am
PM Quote Reply Full Topic
Mark Rosenbaum



Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
 There's a spring-loaded ball on the side of the shaft and a corresponding hole in the knob.  You have to insert a small punch (1/16" maybe) into the hole and press the ball into the shaft until it clears the knob, then separate the parts.

IIRC, the knobless dimmer shown in the attached photo isn't a JH part but should be very close if not identical.

Attachment: 78495 dimmer.jpg (Downloaded 95 times)