View single post by Screenplay
 Posted: 03-15-2016 11:26 pm
PM Quote Reply Full Topic
Screenplay

 

Joined: 07-12-2013
Location: San Francisco, California USA
Posts: 124
Status: 
Offline
I'm cleaning up the wiring harness in the engine bay on 18341 and have a question about the three wires going to the alternator - original Lucas alternator and original wiring. There are two large gauge brown wires and one smaller brown and yellow wire that connect to the alternator. The smaller wire goes through the loom and to the pin block. One of the large brown wires also goes through the loom tape and to the battery junction. The second large brown wire sits outside the loom and and I cannot remember where it goes. The wiring diagram shows it goes to ground. Is that correct? I just don't remember it that way.

Even when you think you've taken every picture you'll need, it always comes up one or two short!

Thanks,
Clinton