View single post by stevegarnjobst
 Posted: 12-02-2015 01:29 pm
PM Quote Reply Full Topic
stevegarnjobst



Joined: 10-22-2015
Location: Maplewood, Minnesota USA
Posts: 36
Status: 
Offline
 This seems like a good thread to ask a question I have about the rear spring assemblies. I'm planning to convert from the stock springs to higher rate 2.5" coil springs. I'll also be installing some adjustable spring perches to permit ride height adjustment.

My question is this: the J-H uses coil spring retainers both top & bottom on the stock springs. Is it possible to run without retainers on the springs, as is common practice on many vehicles? Or, is there sufficient droop in the J-H suspension to require retainers to keep the springs in place and limit droop? I know others have converted to standard coil springs - how did you address this issue? Does adding a rear swaybar reduce the need for spring retainers by limiting droop?

Thanks!

-Steve

p.s. Here's a photo of the spring perches I'm using. They're for a VW Golf, and bolt right onto the J-H rear lower arms.


Last edited on 12-02-2015 01:35 pm by stevegarnjobst