View single post by answerman
 Posted: 10-22-2015 07:36 pm
PM Quote Reply Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 381
Status: 
Offline
Thanks for the input, guys. Still haven't gotten an answer on the size of the bell housing bolts as far as mounting to the stand. I guess I'll just pull a few and take them to the hardware store and match them up with longer ones. Otherwise, the engine is basically ready to come out: peripherals are all removed, and all that's holding it in are the bell housing bolts and the two motor mounts. Planning on pulling it on Saturday, and before going any further mounting it to the stand and taking it outside for a thorough degreasing... it's a mess!