View single post by edward_davis
 Posted: 08-30-2005 12:53 am
PM Quote Reply Full Topic
edward_davis



Joined: 07-06-2005
Location: Eugene, Oregon USA
Posts: 162
Status: 
Offline
I've ordered a switch from http://www.wiringproducts.com that should fit the JH hazard application.  It's a DPDT on-on switch, and I'm planning on wiring the "bottom" of the old hazard switch to one pole and the "top" to the other.  When it's in the lower position, the power will go in from my "turn signal" fuse and out to the turn signal mechanism, and the hazard circuit will be broken.  Whin it's in the upper position, the power will go from the hazard flasher mechanism out to the lights, and the turn signal circuit will be broken, just as in the orignal application.  If it works, I'll send pictures.  The switch seems to be the right dimensions for the JH, and it only costs $6.35 plus S&H.  If it doesn't work, I'll post that, too, so other folks won't make my mistake.