View single post by gmgiltd
 Posted: 04-04-2015 12:09 am
PM Quote Reply Full Topic
gmgiltd

 

Joined: 07-10-2012
Location: Whitehills , United Kingdom
Posts: 168
Status: 
Offline
 Just a word of warning about the Martin Robey stainless header - the standard of workmanship one I got from them last year was absolutely rubbish. Although the bolt holes lined up the ports didn't and the 'Y' piece was hard up against the frame rail and would not fit. By the time I discovered that I had ground out the ports to match the gaskets. I had to do a fair bit of fabricating to get it sorted out. I sent a strongly worded email with photographs attached to Keith Jackson there suggesting that he calibrate their suppliers and followed up with a phone call a month later to find out what their response was - he had not done anything about it. Make sure they have all the issues sorted out before you buy and also be aware that it is a three piece system - the 'Y' is a separate item.
Gordon.