 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-14-2005 |
| Location: | Columbia, South Carolina USA |
| Posts: | 156 |
| Status: |
Offline
|
I think this one is plastic; you'd want to get a metal one.
Last edited on 03-23-2015 09:13 pm by Jensenman
| View single post by Jensenman | |||||||||||||
| Posted: 03-23-2015 09:12 pm |
|
||||||||||||
Jensenman
|
I have a drill guide which I bought when a cylinder head bolt broke while disassembling an Isuzu Trooper V6. It was definitely accurate enough to center the bit in the broken off piece of head bolt. You'd have to remove the radiator etc for clearance but I bet it would work. I think this one is plastic; you'd want to get a metal one. Last edited on 03-23-2015 09:13 pm by Jensenman |
||||||||||||
|
| |||||||||||||