View single post by Tom Thomson
 Posted: 08-23-2005 01:25 am
PM Quote Reply Full Topic
Tom Thomson

 

Joined: 03-18-2005
Location:  
Posts: 33
Status: 
Offline
 I am seeing lots of messages about adapters and spacers.  It would require some amount of teardown but why not drill new stud holes on whatever bolt circle you desire?  Just rotate the hub or axle about 30 degrees or so, (in the machine) indicate the center, step to the new coordinates and drill.  The rear axle is OK but the front hubs would require a back spotface.  This method would accomodate the stock studs or a different dia and  any machine shop can do the job in 3-4 hrs.

                                        Tom - 13753