View single post by Eric
 Posted: 12-14-2014 10:22 pm
PM Quote Reply Full Topic
Eric

 

Joined: 11-11-2014
Location:  
Posts: 35
Status: 
Offline
 Im using the Delta bushings at the rear. As others have noted, the crush tubes are too small for the bolts. Appears that the correct diameter is about 7/16". Is this correct? Do I just drill them out with a drill press? Also, on my car, 3 of the 4 bolts holding the upper and lower control arms on each side are identical, but the 4th has a slightly different locking nut. It is this way on both sides. As I assumed they were all identical, I have no idea which location the 1 "different" nut goes on each side. Thoughts?

Thanks!
Eric