View single post by answerman
 Posted: 12-02-2014 04:08 pm
PM Quote Reply Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
 Good point, Joachim. I'm just presenting the easiest way to go about it.  Though, if I remember a few posts back he was speaking of keeping the resistor wire in place so using the existing connectors might still be the way to go.

My main point (and I keep seeing it come up here, asking how to remove the instrument panel) is that the tach comes out of the instrument panel so easily. I just hate to see someone spending half a day to remove the instrument panel when it's a 5 minute job to pop the tach out.

Last edited on 12-02-2014 04:11 pm by answerman