View single post by Jim
 Posted: 07-10-2014 02:20 am
PM Quote Reply Full Topic
Jim

 

Joined: 04-16-2005
Location:  
Posts: 5
Status: 
Offline
So, I tried to attach the frame of the soft top to the car. I have a plate on each side of the car behind the seats. This plate has three threaded holes and is held captive and has a bit of adjustment/movement. I can't figure out which combination of holes do I use to attach the soft top frame to. I've tried the lower and middle holes and the middle and upper hole. Yet none seam to allow the frame to fully extend and align with the brackets attached above the windshield. Anyone got a picture of this or can explain where I'm going wrong. The car is a 1975 year