View single post by Dakota123
 Posted: 01-21-2014 07:22 pm
PM Quote Reply Full Topic
Dakota123

 

Joined: 03-20-2009
Location: Colorado USA
Posts: 185
Status: 
Offline
I cobbled together a small-ish two-jaw puller with standoffs under the ears to bear against the inner bearing.  To keep the outer cover in place I periodically braced the bearings against the support web and using a bronze drift tapped (pounded?) the outer cover back to its normal position.

Messy, and there's no turning back since bearing damage is almost inevitable.

Last edited on 01-22-2014 04:22 am by Dakota123