View single post by atgparker
 Posted: 11-30-2013 01:16 am
PM Quote Reply Full Topic
atgparker



Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 90
Status: 
Offline
 Yup it sure does. But the Addco chassis mounted bars end up having a longer effective arm as they are rear set by quite a bit from the OEM mounts shown above. So that makes the bar's relative stiffness less for a given diameter being the same with these two arrangements. It's no wonder that Huffaker Engineering did something completely different for the sway bar when they raced this car.

When I auto crossed mine a few weeks ago with the Addco bars in place I thought I was going to clean house. But the Koni's were wide open so there was no rebound damping resistance and the cars excellent steering response made short work of the excessive body roll but the transitions made nailing the desired route impossible.

I just hope the Koni's on the front are as mal adjusted as were the rear on 11602.