View single post by atgparker
 Posted: 10-21-2013 10:08 pm
PM Quote Reply Full Topic
atgparker



Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 90
Status: 
Offline
So having just replaced the cam shaft seals on 11602, I drove Ortega Hwy. last Saturday to Murrieta, Ca and back. Nice hot afternoon jaunt. It got the temp gauge to almost half way with a 160°F thermo in the water pump housing. But the exhaust CAM seal is flinging oil just as it did before I replaced it. There was a large O-ring behind the intake CAM seal which I did not replace as I suspected it was blocking the oil return galleries which are mostly at the bottom of the seal on the intake but not so on the exaust cam. So, where can we get double lipped viton seals like the picture in subwoofer's post?