View single post by Jim Ketcham
 Posted: 08-18-2013 01:49 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
 Art,
Your coil has an internal 3 ohm resistor and does not require the external ballast resistor. Therefore, the wire from the tach (white/slate) should go directly to the coil + to power the coil. Your Petronix red to coil +. Your Petronix black to coil -. The external ballast resistor not used. The white/yellow from the starter solenoid not used.

I hope this helps.
Jim