View single post by Art DeKneef
 Posted: 12-10-2012 03:57 pm
PM Quote Reply Full Topic
Art DeKneef

 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
 When I did mine in order to remove the metal bush I lightly used a drill bit to remove the metal enough until I could remove the bush. Having a drift the approximate size helped in removing the bush.
 
This wasn't the correct way to peen the bush but I used a rounded metal bar and hammer in order to round over the edges to hold them together.