View single post by answerman
 Posted: 09-19-2012 04:38 am
PM Quote Reply Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
Well, did the experiment I talked about. Started her up, ran her for a bit, then shut her down and pulled the wire off the ballast resistor (the one that runs to the tach). Tried starting her again... she would catch once like she wanted to start and then die. So, that tells me initially that the 12v is going through the tach as it should. Or if it's jumped, it's not under the hood anyway.

Garage will be cleaned and ready tomorrow... then I can start in earnest.