 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-17-2007 |
| Location: | |
| Posts: | 19 |
| Status: |
Offline
|
Tried to start, but fuel pump still does'nt work & no spark at the plugs! Guess I'll start tracing out wires with a ohms meter next?
| View single post by Rob Rawe | |||||||||||||
| Posted: 11-16-2011 11:02 am |
|
||||||||||||
Rob Rawe
|
Removed the existing fuses (35amp). rolled up narrow strip of emery paper the size of fuse x 1/2" lg. & held one end with a needle nose pliers & went over each prong of the fuse holders, & wiped each pair of prongs with a shop towel stuffed in between them. Installed new set of AGC 20amp fuses, have not used the dielectric grease yet. Tried to start, but fuel pump still does'nt work & no spark at the plugs! Guess I'll start tracing out wires with a ohms meter next?
|
||||||||||||
|
| |||||||||||||