View single post by Jay
 Posted: 05-16-2011 04:49 pm
PM Quote Reply Full Topic
Jay



Joined: 08-05-2005
Location: Canton, Ohio USA
Posts: 73
Status: 
Offline
 I noticed gas dripping from what looke like a plug in the bottom of the front carburetor bowl. At first look it appeared that the plug is made of a type of plastic (I'm not sure). I have not yet attempted to take it out. Can anyone tell me what is the best approach to remove it. I believe that I have read that there is an o-ring in there. Do you think an o-ring replacement is all that is required? I don't seem to have any basic problems with the running characteristics of the engine so I am not wanting to venture into any carburator rebuild. Are the parts thet I would need available without the need to purchase an entire rebuild kit? How do I go about fixing this leak?

Thanks for any and all help that can be provided.

Jay