View single post by rossjfox
 Posted: 04-06-2011 04:35 pm
PM Quote Reply Full Topic
rossjfox

 

Joined: 05-19-2008
Location: Montville, New Jersey USA
Posts: 56
Status: 
Offline
Anton,

I fitted the Addco front sway bar.  (As well as the rear.  These must be done in pairs or be prepared for some, shall we say, "entertaining" handling.)

Fitting the front bar is not a challenge as long as the factory put your lower A-arms on right way around.  There are tabs on the lower a-arms where the sway bar connects.  These tabs need to be pointed towards the rear of the car.  On many cars, the factory assembled them with the lower A-arms switched left to right and thus the tabs point to the front of the car.  If the A-arms are correct, than you can just bolt the front bar on and drill 4 holes in the frame rails for the brackets.  If the A-arm tabs are pointing in the wrong direction, than the A-arms need to be switched left to right.  A doable job, but much more work than just installing the sway bar.

Ross