View single post by subwoofer
 Posted: 03-04-2011 07:04 pm
PM Quote Reply Full Topic
subwoofer

 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
 While I try to teach myself SolidWorks, I figured I could do something useful instead of fiddling about with the examples in the books. The point of the exercise is to build a model good enough to see what front calipers will fit or what modifications would have to be made to make them fit.

For the time being, Ms. Jensen is actually in one piece, so I don't want to disassemble too much to make measurements. Could someone who either has their front suspension in pieces or have extra parts lying about take measurements of the hub (inside and out) and the knuckle/spindle? I am not hoping for a pretty drawing, a napkin sketch with fairly accurate dimensions is more than sufficient!

I will naturally share the files with the community if there is any interest.

PS: Rear disc conversion will be next...

--
Joachim