View single post by SpeedyMitch
 Posted: 12-22-2010 03:22 pm
PM Quote Reply Full Topic
SpeedyMitch



Joined: 12-17-2009
Location: Hailey, Idaho USA
Posts: 83
Status: 
Offline
Lash Russell wrote: Was this for the earlier (MK I, I think) engines?

The bulletin is JH 74-17

Subject: Oil Pressure Delay

To decrease the oil pressure build up time, an air bleed hole has been incorporated in production at serial number 14875 on the pressure side of the oil pump body in the auxiliary housing. This bleed hole will allow air trapped in the oil galleries to be pumped out, therefore assist in oil pump priming.

The bulletin gives details on how and where to drill the hole.